Arescom Inc. AG2000S Manual De Usuario
AG2000Series Software User’s Guide
June, 2002
7
Location & Placement
LAN
There are 4 sets of LEDs to indicate the Ethernet transmission status of 4 10/100 BaseT LAN ports of
the AG2000S. Each set includes a LINK and an ACT LED.
the AG2000S. Each set includes a LINK and an ACT LED.
LINK:
The LINK LED is solid when a valid Ethernet link is established.
ACT:
The ACT LED flashes when there is data activity on this port.
WLAN
The WLAN LED flashes slowly when there is no activity on this wireless interface. The LED flashes
quickly when data is flowing from/to this interface.
quickly when data is flowing from/to this interface.
2.1.4 AresGate 2000S - Back Panel
Figure 2.4
AresGate 2000S Back Panel Ports and Switch
LAN (Port 1 - Port 4)
The 4 LAN ports connects the AG2000 to PCs, hubs or switches on your wired LAN network.
POWER
The POWER port is where you connect the AC power adapter.
ON/OFF Switch
Utilize this ON/OFF switch to turn the AG2000 on or off.
WAN
The 10BaseT WAN port is where you connect your existing Cable/DSL modem.
Antenna Connector
The included external antenna needs to be securely attached to the antenna connector located on the far
right side of the back panel.
right side of the back panel.
2.2 Location & Placement
•
For maximum wireless coverage, locate an installation spot with a minimum number of walls,
ceilings or other objects that will block the radio transmission between the AG2000 and the
wireless clients.
ceilings or other objects that will block the radio transmission between the AG2000 and the
wireless clients.
•
Choose an installation location that is away from direct sunlight.
•
It is important to place the AG2000 in the center of all the wireless clients.
•
Place the AG2000 on the predetermined surface that allows you to see the back panel for con-
venient cable connection.
venient cable connection.