Arescom Inc. AG2000S Manual De Usuario
AG2000Series Software User’s Guide
June, 2002
5
CHAPTER 2:
HARDWARE INSTALLATION
This chapter describes the front and back panel layouts and installation procedure for both
AG2000 and AG2000S.
AG2000 and AG2000S.
2.1 Panel Information
2.1.1 AresGate 2000 - Front Panel
Figure 2.1
AresGate 2000 Front Panel LEDs
PWR (Power)
The PWR LED is ON when power is supplied to the AG2000.
DIAG (Diagnostic)
The DIAG LED indicates the AG2000 is in a self-diagnostic mode during boot-up.
Once it boots up successfully, the LED will automatically turn off. If there is a soft-
ware malfunction or a problem with the unit, the LED will remain on.
Once it boots up successfully, the LED will automatically turn off. If there is a soft-
ware malfunction or a problem with the unit, the LED will remain on.
WAN
The WAN LED displays the 10BaseT WAN port Ethernet connection status between
the AG2000 and a broadband device (e.g. Cable modem or DSL modem). The WAN
LED is solid on when a valid Ethernet link is established. The LED flashes when
there is data activity on this port.
the AG2000 and a broadband device (e.g. Cable modem or DSL modem). The WAN
LED is solid on when a valid Ethernet link is established. The LED flashes when
there is data activity on this port.
LAN
The LAN LED displays the 10BaseT Ethernet connection between the AG2000 and
an Ethernet network. The LAN LED is on and remains solid if there is a valid link.
The LED flashes when there is data activity on this port.
an Ethernet network. The LAN LED is on and remains solid if there is a valid link.
The LED flashes when there is data activity on this port.
WLAN
The WLAN LED flashes slowly when there is no activity on this wireless interface.
The LED flashes quickly when data is flowing from/to this interface.
The LED flashes quickly when data is flowing from/to this interface.