HydroPoint data systems inc. WT008 Manual De Usuario

Turn the Lower Line dial to select a lock phase. Your choices are:

•

C, or

•

None (Default Setting).

When you lock onto a phase other than “None,” the controller will
beep when receiving your activation message.

* Note: This feature is used only at ET Everywhere Service
activation. After activation all phases are ‘live’ and will be used to
receive daily ET updates. Locking on a phase at activation allows
for faster activation process. At midnight of the day of activation,
the controller will “unlock.”

Displaying the Microzone

The microzone provides the specific location of the controller and
enables the WeatherTRAK ET plus to receive its daily local ET updates.

To view the microzone, turn the Upper Line dial until you see:

This displays the current microzone. The value shown is the default
value.

Note:

This value is transmitted to each controller during ET

Everywhere Service activation. You do not set this value.

MICROZONE

12345678

Setting Up Your WeatherTRAK ET Plus

Viewing the Serial Number

Under “Setup,” to view the serial number of your controller, turn the
Upper Line

dial until you see:

Please write down your serial number for future reference.

SN #::___________________________

Viewing the Phase Integrity

To view the phase integrity, which indicates wireless reception
strength, turn the Upper Line dial until you see:

You should leave the phase integrity screen on for several minutes to
acquire all of the data that HydroPoint is transmitting.

Setting the Lock Phase

To activate your controller, you will be asked to lock to a phase. Do
not perform this setting until the HydroPoint Customer Service
Representative asks you to do it.

To do this:

Turn the Upper Line dial until you see:

LOCK PHASE

None

PHASE INTEGRITY

A=68 B=81 C=73 D=74

SERIAL NUMBER

00649127

Setting Up Your WeatherTRAK ET Plus