HydroPoint data systems inc. WT008 Manual De Usuario
Setting the Water District Number
HydroPoint provides a water district number if, and only if, you are a
registered and willing participant in a water agency program. This
may be set manually. This identification will allow your WeatherTRAK
ET plus to be notified of specific water agency requirements.
registered and willing participant in a water agency program. This
may be set manually. This identification will allow your WeatherTRAK
ET plus to be notified of specific water agency requirements.
To set the water district number:
1.
Turn the Upper Line dial until you see:
2.
Turn the Lower Line dial to select a number from “0” to “9.”
3.
Continue to turn the Upper Line and Lower Line dials until you
have selected the correct five-digit number.
have selected the correct five-digit number.
* Note: There are some menu displays that you will set later. The
following settings are not mandatory and will be covered in
Chapter 4.
following settings are not mandatory and will be covered in
Chapter 4.
SET WATER DIST.# Digit 1
12345
–
Setting Up Your WeatherTRAK ET Plus
21
Displaying the WT Version
This information will be used for ET Everywhere Service activation only.
To view this, turn the Upper Line dial until you see:
The number you see is the current WeatherTRAK ET plus version.
Setting the Stacking Option
Stacking is an irrigation term for sequential versus simultaneous
operation of two or more schedules.
operation of two or more schedules.
Your controller has two schedules: A and B.
Stacking (Stacking = yes, the default setting) means that all
stations on both schedule A and schedule B will run sequentially (one
at a time) until all programmed stations have completed their cycle
run time. Non-stacking (Stacking = no) means that the stations in
program A can operate at the same time as the stations in program B
(simultaneous operation). The hydraulics of your irrigation system
determine whether or not non-stacking can be set.
stations on both schedule A and schedule B will run sequentially (one
at a time) until all programmed stations have completed their cycle
run time. Non-stacking (Stacking = no) means that the stations in
program A can operate at the same time as the stations in program B
(simultaneous operation). The hydraulics of your irrigation system
determine whether or not non-stacking can be set.
1.
Turn the Upper Line dial until you see:
2.
Turn the Lower Line dial to select:
•
Yes (default), or
•
No.
STACKING
Yes
WT VERSION
ver 00300a29
Setting Up Your WeatherTRAK ET Plus
20