Cisco Systems 102053 Manual De Usuario
C I S C O C O N F I D E N T I A L - D r a f t 2
2-4
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-03
Chapter 2 Installing the Access Point
Before Beginning the Installation
Installation Above Suspended Ceilings
The access point uses a metal enclosure having adequate fire resistance and low smoke-producing
characteristics suitable for operation in a building’s environmental air space (such as above suspended
ceilings) in accordance with Section 300-22(c) of the NEC. For mounting instructions, refer to the
characteristics suitable for operation in a building’s environmental air space (such as above suspended
ceilings) in accordance with Section 300-22(c) of the NEC. For mounting instructions, refer to the
Caution
Only the fiber-optic power injector (AIR-PWRINJ-FIB) has been tested to UL 2043 for operation in a
building’s environmental air space, all other power injectors and power modules are not tested to UL 2043
and should not be placed in a building’s environmental air space, such as above suspended ceilings.
building’s environmental air space, all other power injectors and power modules are not tested to UL 2043
and should not be placed in a building’s environmental air space, such as above suspended ceilings.
Note
If you plan to mount the access point in environmental air space and will upgrade to a 5-GHz radio, Cisco
recommends that you mount the access point horizontally with its antennas pointing down. Doing so will
result in the access point complying with regulatory requirements for environmental air space after the
5-GHz radio is installed.
recommends that you mount the access point horizontally with its antennas pointing down. Doing so will
result in the access point complying with regulatory requirements for environmental air space after the
5-GHz radio is installed.
Before Beginning the Installation
Before you begin the installation process, please refer to
,
become familiar with the access point’s layout, connectors, and 5-GHz module location.
Figure 2-1
Access Point Layout and Connectors
1
2.4-GHz antenna connectors
5
Mode button
2
48-VDC power port
6
Status LEDs
3
Ethernet port (RJ-45)
7
Mounting bracket
4
Console port (RJ-45)
1
2
3
4
6
7
1
5
65847