Cisco Systems 102053 Manual De Usuario

While installing the access point, you must perform the following operations:

If you have a 2.4-GHz radio upgrade kit, refer to the 

.

If you have a 5-GHz radio module upgrade kit (RM20A, RM21A,or RM22A) refer to the 

If your access point has a built-in 2.4-GHz radio, connect a single antenna or dual diversity antennas 
(refer to the 

). 

If your access point has an installed RM22A radio module, connect a single antenna or dual diversity 
antennas (refer to the 

Connect Ethernet and power cables (refer to the 

).

Configure basic settings (refer to 

Configure security and other access point options. 

Use the mounting kit to install the access point on a convenient flat horizontal or vertical surface, 
such as a desktop, book shelf, file cabinet, wall, or ceiling. For additional information on mounting, 
refer to 

The access point supports a single antenna or dual diversity antennas. Two RPTNC antenna connectors 
are provided on the back of the unit for the 2.4-GHz radio. 

RPTNC antenna connectors are used for both the 2.4 GHz and 5 GHz radios. You must be careful to 
ensure that you connect your 2-4 GHz antenna to the 2-4 GHz radio connectors (refer to 

connector locations). 

To attach your antenna or antenna cable to the access point, follow these steps:

Attach an antenna or antenna cable to the 2.4-GHz Right/Primary (RPTNC) antenna connector on the 
back of the access point and hand tighten. If you are using two antennas for diversity coverage, attach 
the second antenna or antenna cable to the 2.4-GHz Left (RPTNC) antenna connector.

If you are using a Cisco Aironet 2 dBi antenna, orient the antenna depending on how you intend to mount 
the access point.

On a table or desk, orient the antenna straight up.

On a vertical surface, such as a wall, orient the antenna straight up.

On a ceiling, orient the antenna straight down.

If you are using another Cisco Aironet antenna, refer to the antenna mounting instructions that came with 
your antenna.