Cisco Systems 102053 Manual De Usuario

Although enhanced editing mode is automatically enabled, you can disable it.

To re-enable the enhanced editing mode for the current terminal session, enter this command in 
privileged EXEC mode: 

ap# terminal editing

To reconfigure a specific line to have enhanced editing mode, enter this command in line configuration 
mode: 

ap(config-line)# editing

To globally disable enhanced editing mode, enter this command in line configuration mode: 

ap(config-line)# no editing

 shows the keystrokes that you need to edit command lines.

Move around the command line to 
make changes or corrections.

Ctrl-B or the left arrow 
key

Move the cursor back one character. 

Ctrl-F or the right arrow 
key

Move the cursor forward one character. 

Move the cursor to the beginning of the command line.

Move the cursor to the end of the command line.

Move the cursor back one word.

Move the cursor forward one word.

Transpose the character to the left of the cursor with the 
character located at the cursor.

Recall commands from the buffer and 
paste them in the command line. The 
access point provides a buffer with 
the last ten items that you deleted.

Recall the most recent entry in the buffer.

Recall the next buffer entry.

The buffer contains only the last 10 items that you have 
deleted or cut. If you press Esc Y more than ten times, you 
cycle to the first buffer entry.

Delete entries if you make a mistake 
or change your mind.

Delete or Backspace

Erase the character to the left of the cursor.

Delete the character at the cursor.

Delete all characters from the cursor to the end of the 
command line.

Ctrl-U or Ctrl-X

Delete all characters from the cursor to the beginning of 
the command line.

Delete the word to the left of the cursor.

Delete from the cursor to the end of the word.