Cisco Systems 102053 Manual De Usuario

C I S C O C O N F I D E N T I A L - D r a f t 2

6-3

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

OL-4310-03

Chapter 6 Mounting Instructions

Mounting on a Horizontal or Vertical Surface

A mounting hardware kit is provided that contains the hardware and fasteners necessary to mount the
access point. Refer to the

to identify the materials you need to mount your access point, then

go to the section containing the specific mounting procedure.

Mounting on a Horizontal or Vertical Surface

Follow these steps to mount the access point on a horizontal or vertical surface.

Step 1

Use the mounting bracket as a template to mark the locations of the four mounting holes.

Step 2

Drill one of the following sized holes at the locations you marked:

•

3/16 in. (4.7 mm) if you are using wall anchors

•

1/8 in. (6.3 mm) if you are not using wall anchors

Step 3

Install the anchors into the wall if you are using them. Otherwise, go to Step 4.

Step 4

Secure the mounting bracket to the surface using the #8 fasteners.

Note

On a vertical surface, mount the bracket with its security hasp facing down.

Step 5

Attach the access point to the mounting bracket.

Note

You can make your installation more secure by mounting it to a stud or major structural member
and using the appropriate fasteners.

Table 6-1

Material Needed to Mount Access Point

Mounting Method

Materials Required

In Kit

Horizontal or vertical surface

Four #8 x 1 in. (25.4 mm) screws
Four wall anchors
3/16 in. (4.7 mm) or 3/32 in. (2.3 mm) drill bit
Drill
Standard screwdriver

Yes
Yes
No
No
No

Suspended ceiling

Two caddy fasteners with studs
Two plastic spacers
Two 1/4–20 Keps nuts with built-in washers
Standard screwdriver
Appropriate wrench or pliers

Yes
Yes
Yes
No
No