Cisco Systems 102053 Manual De Usuario

C I S C O C O N F I D E N T I A L - D r a f t 2

8-7

Cisco Aironet 1200 Series Access Point Hardware Installation Guide

OL-4310-03

Chapter 8 5-GHz Radio Module Upgrade

Installing a 5-GHz Radio Module

Attaching the Compliance Label

There are three places on the 1200 series access point dedicated to compliance labels, one for the product
compliance label and two for the radio compliance labels. The label locations are shown in

Figure 8-7

Figure 8-6

Access Point Compliance Label Locations

The product compliance label always occupies the top space (location 1). The two spaces below the
product compliance label (locations 2 and 3) contain the radio compliance labels. Whether or not
locations 2 or 3 contain labels depends on how your access point is configured. For example, the access
point could have two radio compliance labels (one for each radio device installed), or the access point
could have only a product compliance label, depending on how it was ordered.

Make sure that your access point has the correct labels after you install or upgrade its radio configuration
so that it will be in compliance with regulations in your country.

Follow these steps to place the label correctly:

Step 1

Refer to

Figure 8-7

for the compliance label locations.

Step 2

Remove the backing paper from the 5-GHz radio compliance label.

Step 3

If your access point has a 5-GHz radio compliance label, place the new label over the existing label.

Step 4

If your access point does not have a 5-GHz radio compliance label, place the new label in an empty
location (see

Figure 8-7

Product compliance label

Radio compliance label

103640