ADC Telecommunications Inc. PSM230WM Manual De Usuario

Descargar
Página de 51
Page 22
FlexWave Prism Remote Unit RF Module Installation Guide
©2015 TE Connectivity
TECP-77-141 Issue 8  •  300001744178 Rev H  •  August 2015
Guard against Damage from Electro-Static Discharge
CAUTION! Electro-Static Discharge (ESD) can damage electronic components. To prevent ESD damage, always wear 
an ESD wrist strap when working with a Prism Remote Unit or when handling any of its 
components—including the RF Modules. Connect the ground wire on the ESD wrist strap to an earth 
ground source before touching the Prism Remote Unit or any of its components. Wear the wrist strap 
the entire time that you work with the Prism Remote Unit and its components. 
CAUTION! Place Prism RF Modules in anti-static packing material when transporting or storing them.
Unpack and Inspect the RF Module
1
Inspect the exterior of the shipping container(s) for evidence of rough handling that may have damaged the 
components in the container.
2
Unpack each container while carefully checking the contents for damage and verify with the packing slip.
3
If damage is found or parts are missing, file a claim with the commercial carrier and notify TE Customer 
Service (see 
). Save the damaged cartons for inspection by the carrier.
4
Save all shipping containers for use if the equipment requires shipment at a future date. 
CAUTION! Handle the RF Module with care during installation. Be especially careful to not damage the 
thermal-interface material (TIM), which is attached to the LPA, DARTs, and/or Motherboard with TX/RX 
boards. If the TIM is damaged, the LPA can overheat. Before installing the RF Module, check to see if the 
heatsink material is gouged or cracked. If the TIM is damaged, do not install the RF Module and contact 
TE Connectivity for assistance (see 
 for contact information).
CAUTION! If the thermal-interface material is damaged, the installation and use of the RF Module may void the 
warranty of the RF Module.