TransCore IT241005422 Manual De Usuario
IT2410 Tag Programmer User Guide
D-12
Note: Command 3000H (host tag command) has an extended command set that par-
allels the tag-reader command set for the interface between the reader and tag on the
RF interface.
allels the tag-reader command set for the interface between the reader and tag on the
RF interface.
Identify
The Identify command requests the identification (ID) and version numbers of the
programmer application firmware, the RF module firmware, and the programmer
hardware version.
programmer application firmware, the RF module firmware, and the programmer
hardware version.
Data associated with Identify command for the programmer is shown in Table D-6.
Vendor — The first group of eight ASCII characters provides the host with a vendor
name, AMTECH, followed by two spaces. The symbol ^ indicates a space or an ASCII
character 20H in this document.
name, AMTECH, followed by two spaces. The symbol ^ indicates a space or an ASCII
character 20H in this document.
Hardware version — The next two bytes provide a version of the hardware. The gen-
eral format of the vendor and hardware version is illustrated below:
eral format of the vendor and hardware version is illustrated below:
Reserved/Spare
a
Spare
Spare
Spare
Reserved
Spare
Spare
Reserved
05601H
0564H-0565H
0572H-0579H
057FH
06A4H-06A5H
06B2H-06BEH
06BFH
a. These commands have not been delegated a command type and are not listed in this section.
Table D-5 Tag Programmer Commands (continued)
Table D-6 Identify Command Code
Byte
Bit 7
0-7
Vendor
8-9
Hardware version
10-29
Boot S/W ID
30-49
Application S/W ID
50-69
S/N on programmer
70-89
Reserved field on programmer