GatesAir Inc. ULXATSC Manual De Usuario
2/19/10
888-2715-001
2-3
WARNING: Disconnect primary power prior to servicing.
Section 2 Operation
Maxiva ULX ATSC Series
User Manual
User Manual
NOTE:
The system control buttons described above will be referred to as hardware con-
trol buttons in the following manual text.
trol buttons in the following manual text.
Figure 2-2 TCU Front Panel Lowered
Should the GUI screen go gray, i.e., the software buttons or symbols are still visible but
have turned shades of gray instead of the usual color scheme, a TCU reset may be
required. To reset the TCU, pull down the GUI panel exposing the circuit cards in the
TCU chassis as shown in Figure 2-2. The second board from the right is the PCM
board. The TCU reset button is located about toward the center of the board and it faces
outward toward the user. Use the tip of a pencil or pen to gently depress the small black
button.
have turned shades of gray instead of the usual color scheme, a TCU reset may be
required. To reset the TCU, pull down the GUI panel exposing the circuit cards in the
TCU chassis as shown in Figure 2-2. The second board from the right is the PCM
board. The TCU reset button is located about toward the center of the board and it faces
outward toward the user. Use the tip of a pencil or pen to gently depress the small black
button.
NOTE:
It will take approximately two minutes for the TCU to reset. If the transmitter is
on the air, resetting the TCU will NOT affect transmitter operation.
on the air, resetting the TCU will NOT affect transmitter operation.
A TCU reset can also be accomplished by pressing the Local GUI SYSTEM ADMIN
screen REBOOT button.The screen and button are shown in Figure 2-19 on page 2-24.
screen REBOOT button.The screen and button are shown in Figure 2-19 on page 2-24.
PCM
Reset
Reset