Checkpoint Systems Inc. FISOLRR Manual De Usuario
I L S O p e n P l u s E x i t A n t e n n a I n s t a l l a t i o n : I n s t a l l t h e C o v e r P l a t e s
1-17
1
The diagram above shows the cover plates (5) and (6) as well as the frame side sections
(7). The upper frame section is already sitting on the antenna body as described in
(7). The upper frame section is already sitting on the antenna body as described in
Figure 1.16
Cover plate in antenna base
2
Insert cover plates in the antenna base and upper frame section as shown below. The
cover plates with the painted, non-transparent section belong on the open side of the
antenna body. This covers the antenna conductors and electronics.
cover plates with the painted, non-transparent section belong on the open side of the
antenna body. This covers the antenna conductors and electronics.
Figure 1.17
Sliding the frame side sections down
3
Plug the side molding pieces in to the antenna body from the side and slide them down.
Start inserting with the bottom key first, then the middle, then the top key.
Start inserting with the bottom key first, then the middle, then the top key.
Cover plate inserted into sill of
base.
base.
Key slides
into there
into there