Avaya Canada Corporation NTMQ75AA Manual De Usuario
20 / Picocell 1900 Antenna System Installation
Method 12-0152
September 4, 1998
Draft
Procedure 3 – Mounting Directional Antenna and Wall Bracket
1.
Approximately position the antenna and bracket. Use the bracket or
template provided with the antenna to mark and drill pilot holes for the
wall anchors. See Figure 10.
template provided with the antenna to mark and drill pilot holes for the
wall anchors. See Figure 10.
2.
Drill the Cable access hole if required.
3.
Use the two screw holes on the mounting brackets back plate to mark
the screw holes on the wall. screw the antenna bracket in place. Position
the antenna just above the access hole
the screw holes on the wall. screw the antenna bracket in place. Position
the antenna just above the access hole
4.
The cable may be run down the outside wall surface from the ceiling .
For installations in buildings with hollow walls, the cable may be passed
through the cable hole in the mounting bracket through the wall and then
up into the ceiling cavity.
For installations in buildings with hollow walls, the cable may be passed
through the cable hole in the mounting bracket through the wall and then
up into the ceiling cavity.
Note: For surfaces that will not accept wood screws (such as concrete,
brick and steel), you must select and supply the appropriate hardware
yourself.
brick and steel), you must select and supply the appropriate hardware
yourself.
Figure 10 –
Directional Antenna Wall Mounting
Wall Mount Bracket
+/- 30 degree Swivel
+/- 30 degree Swivel
. 4 8 m m
pilot hole
pilot hole
6 0 .0 °
Swivel
Dry Wall
Anchors x 2
Anchors x 2
120 degree Directional
A n t e n n a
A 0 7 3 6 1 8 8
A n t e n n a
A 0 7 3 6 1 8 8
'N' Female
C o n n e c t o r
C o n n e c t o r