Canberra Industries RMSA7070822 Manual De Usuario
2.1.1 Changing the Seal Batteries
• Open the Seal case. See Figure 8 below, which just shows the Seal circuit card
assembly.
• The two 3.6-volt Lithium AA batteries are on the top of the board in battery holders.
• Remove old batteries and insert two fresh batteries. Note that the battery positive
terminal must align with where the arrows are pointing. There are also battery
orientation symbols in the battery holders.
orientation symbols in the battery holders.
• NOTE: The prototype Seal has a power switch which must be turned on (slide away
from the end of the board with the fiber optic cable ferrules) to enter the command
interface for personality programming.
interface for personality programming.
• Reprogram the Seal personality, close the Seal case and install a fiber loop.
• Confirm proper start-up by verifying that the red LED visible through the bottom of the
Seal case flashes 5 times and then turns off.
Figure 8 Battery Holders (Seal Not in Case)
Battery
Holders for
Batteries
Holders for
Batteries
REMOTELY MONITORED SEAL ARRAY(RMSA)
SFG-MAN-001
REVISION: 1.7
2016 CANBERRA
16