Canberra Industries RMSA7070822 Manual De Usuario
2.1.2 Programming the Seal
The picture below illustrates the hardware set-up for the Seal programming phase. In Figure 9
the Programming Card and Seal are outside of their respective cases while Figure 10 shows
the Programming inside its case. The hardware shown are the RMSA Programmer with USB
cable, an 8-pin cable to support the Seal console and a PICKit2 Programming Dongle with
USB-mini cable to support Seal microcontroller programming. The connections are the same
if an MPLAB ICD3 Programming and Emulation module is used instead of the PICKit 2. Both
USB cables (one from the PICKit 2 or ICD3 and one from the Programmer) are attached to the
host PC. The set-up for the Windows terminal program such as HyperTerm or TeraTerm to
be used with the Programmer Card is as follows: 8 data bits, No parity, 1 stop bit, 19.2 KBaud,
no flow control. Once the Seal has been properly configured and programmed, all dongle
connections may be removed and the Seal can operate stand-alone.
the Programming Card and Seal are outside of their respective cases while Figure 10 shows
the Programming inside its case. The hardware shown are the RMSA Programmer with USB
cable, an 8-pin cable to support the Seal console and a PICKit2 Programming Dongle with
USB-mini cable to support Seal microcontroller programming. The connections are the same
if an MPLAB ICD3 Programming and Emulation module is used instead of the PICKit 2. Both
USB cables (one from the PICKit 2 or ICD3 and one from the Programmer) are attached to the
host PC. The set-up for the Windows terminal program such as HyperTerm or TeraTerm to
be used with the Programmer Card is as follows: 8 data bits, No parity, 1 stop bit, 19.2 KBaud,
no flow control. Once the Seal has been properly configured and programmed, all dongle
connections may be removed and the Seal can operate stand-alone.
Figure 9 Out of Case Seal and Programmer Set -up
Figure 10 Seal Programmer Inside Case
REMOTELY MONITORED SEAL ARRAY(RMSA)
SFG-MAN-001
REVISION: 1.7
2016 CANBERRA
17