CEI Conrad Electronic International Limited RCE-NOVAX350 Manual De Usuario
28 | Calibration
27.1 Calibrating via app or manually?
The recommended way to calibrate the »NovaX 350 and learn the channels is via the
EYECONTROL app (iOS and Android). Follow the instructions given in the app. Note
[ Fig. 7 ].
EYECONTROL app (iOS and Android). Follow the instructions given in the app. Note
[ Fig. 7 ].
If you decide for the app, only follow the in-app instructions
and directly continue with installing the propellers after
completing the calibration.
and directly continue with installing the propellers after
completing the calibration.
Motor start test
Completed
Manually
Learning the channels
Gyro calibration
Compass calibration
EyeControl app
Learning the channels
Gyro calibration
Compass calibration
Fig. 7
27.2 What to do if calibration fails
Each of the calibration procedures can fail and is indicated by 3 prominent beep sounds
(3 beeps). For example, the transmitter learning procedure fails if you provide wrong stick
input. In case of failure:
1. Move away from magnetic interferences
2. Disconnect the flight battery and re-connect it
3. Restart the procedure.
Successfully completed calibration procedures can be skipped.
(3 beeps). For example, the transmitter learning procedure fails if you provide wrong stick
input. In case of failure:
1. Move away from magnetic interferences
2. Disconnect the flight battery and re-connect it
3. Restart the procedure.
Successfully completed calibration procedures can be skipped.
27.3 Switching between learning/calibration
You do not need to perform the calibrations in sequence. All calibrations must be performed.
27.3.1 Starting and ending a calibration procedure
1. Remove the canopy.
2. Press and hold the PCB button on the flight control board for approx. 2 seconds to
2. Press and hold the PCB button on the flight control board for approx. 2 seconds to
put the »NovaX 350 into the calibration mode. If you decide to calibrate channels,
gyro and compass in one attempt, there is no need to repeat this action before each
calibration procedure.
gyro and compass in one attempt, there is no need to repeat this action before each
calibration procedure.
3. Switch to a calibration procedure (channel learning, gyro, or compass). See [ Fig. 8 ].
4. Double tap the PCB button (2x) to start the calibration procedure. Pay attention to the
4. Double tap the PCB button (2x) to start the calibration procedure. Pay attention to the
colour indications provided by the front LEDs. See
.
5. Tap the PCB button once (1x) to complete a particular calibration procedure.
6. Replace the canopy.
6. Replace the canopy.
Diagram [ Fig. 8 ] illustrates the functions of the PCB button: