CEI Conrad Electronic International Limited RCE-NOVAX350 Manual De Usuario
Calibration | 29
Calibrate
Calibrate
Calibrate
Channel learning
Compass
Gyro
1x
Fig. 8
27.3.2 Front LED colours when calibrating
Channel learning
Gyro
Compass
27.4 Binding transmitter and receiver
88014RC RtF: Receiver and transmitter were bound during
production. Proceed with channel learning.
If re-binding should become necessary at some point,
follow the given steps.
production. Proceed with channel learning.
If re-binding should become necessary at some point,
follow the given steps.
88014RC RtF: Refer to the operating instructions of the
transmitter and receiver (89102RC) for more information
on the binding and learning procedure.
transmitter and receiver (89102RC) for more information
on the binding and learning procedure.
> Use your own 2.4 GHz transmitter to control the »NovaX 350; operate it via PPM.
> Please carry out the configuration of the »NovaX 350 as described in this chapter.
Channel learning is essential as otherwise the »NovaX 350 will not recognize your
transmitting equipment.
transmitting equipment.
> If you use your computer remote control, program it without a mixer in the standard
program.
> Basically, you can configure the controls to your liking. However, it is recommended
that beginners follow the given examples.
> By default, the »NovaX 350 is configured to MODE 2.
> If your transmitter does not provide two 3-way-toggle-switches please refer to the
workaround explained in
The following sections will guide you through the installation process and set-up. Do not
skip any sections as they are interdependent.
skip any sections as they are interdependent.
27.4.1 Preparing the transmitter (Tx)
1. Ensure that all mixing is deactivated, throttle curves are linear, trims are centered and
all travel is set to maximum range.
2. Move the throttle stick to its zero position (88014RC RtF: Make sure that the throttle
stick is in its mid-position; the sticks are spring loaded and are centered by default).
3. Set all switches to their default positions (0 or 1 respecively).
4. Connect the supplied PPM receiver to the PPM_IN (PCB-5) and TELEMETRY
4. Connect the supplied PPM receiver to the PPM_IN (PCB-5) and TELEMETRY
(PCB-4) port at the front of the power board.
27.4.2 Binding
> Bind the PPM receiver with your transmitter. Refer to the operating instructions of your
transmitter and PPM receiver.
> Futaba
®
FASST systems: use the 7 channel mode.
> In the event that no PPM receiver is detected, the learning mode is not going to be activated.