GE Inspection Technologies LP 7260H Manual De Usuario
12
07/30/2014
Unpacking and Putting Away
the System (Small Case)
Caution: If you do not pack the system carefully, as
described here, damage might occur.
1
– The insertion tube (shown in red for clarity) is held in the
case’s internal storage reel, which is accessed through the
orange funnel shown here. Install the insertion tube before
installing the probe-and-handset assembly and remove it
after removing the probe-and-handset assembly. Be sure
to straighten any loops or twists in the insertion tube before
feeding it into the funnel. Note that the insertion tube’s rubber
Torsional Strain Relief base should be routed through the case’s
curved passage shown here.
Caution: Before using the camera system, install an
optical tip or the head guard, which prevents damage to
the tip-attachment mechanism. Keep the head guard on
whenever no optical tip is in place.
2
– Install clamp in the orientation shown here (clamp and mounting bracket assembly appears at left)
3
– Power supply / Battery Charger and Mounting Bracket are oriented and installed in this slot
4
– Battery must be removed prior to installing the iQ in the case.
5
– Rigidizer
6
– A case holding tips (or cleaning kit) fits in this slot.
7
– Gripper may be used alone, or with Rigidizer, to aid in orienting camera.