GE Inspection Technologies LP 7260H Manual De Usuario

Descargar
Página de 83
14
07/30/2014
The Visual iQ is powered by a 10.8 V (nominal), 73 Wh, 6.8 Ah Lithium Ion battery.
Installing the Battery
Insert the battery into the handset. The battery is installed properly when the latching 
mechanism is engaged.
 Caution—Do not force the battery (
1
) into the handset (
2
), as damage may occur. 
The battery is keyed and may only be installed in the proper orientation.
Removing the Battery
Press battery release button (
3
) to release the battery. 
 Caution—Do not remove the battery while the system is operating.
Battery Charge Level
Check the battery charge by pressing the battery symbol (
4
) on the front of the battery. 
Each light (
5
) represents approximately 20% of the battery charge capacity.
Charging the Battery
Connect the DC output of the battery charger into the Visual iQ battery (
6
) and then 
plug the included AC to DC power adaptor into a suitable AC power source. The LED 
battery lights will illuminate according to the amount of charge attained. The system 
may operate while charging.
Note: The battery may be charged while connected to an operating Visual iQ or while 
disconnected from the iQ. 
Note: When the battery is fully charged, the LED battery lights will turn off.
Note: Battery run time approximately equals battery charge time; therefore, a two hour 
battery will take approximately two hours to charge. Charging time will be longer if the 
battery is connected to an operating Visual iQ system while charging. 
Note: All batteries are shipped with a partial charge. Batteries should be fully charged 
prior to use.