Cypress Semiconductor CapSense® Controller kit CY3280-BK1 CY3280-BK1 CY3280-BK1 Manual De Usuario

CY3280-BK1 Universal CapSense Controller Quick Start, Doc. # 001-37959 Rev. **

7

2.

Use the Board as Factory Programmed

The examples in this Quick Start are for the CY3280-20x34 and CY3280-SLM Linear Slider Module 
boards only.

The CY3280-20x34 board is preprogrammed with demonstration firmware. When powered by a 
PSoC MiniProg, a CY3240-I2USB Bridge, or an optional external power supply, the LEDs light up 
when a finger touches one of the buttons or the slider.

These instructions assume your board has not been reprogrammed from the factory settings. If it 
has, and you would like to follow along with this demonstration, follow the instructions in the Reset-
ting the Board to the Original Factory Programming section on page 5, and then start this example 
with the Power the Board section below.

2.1  Connect your computer to the CapSense test board ISSP Connector (J3) 

 using the PSoC 

MiniProg and a USB cable. If this is your first time using the MiniProg, you will need to install the 
driver using these steps before proceeding:

a. When the Found New Hardware Wizard opens, select the Install the software automati-

cally (Recommended) option and click Next.

b. A warning message may tell you the software you are trying to install has not passed Win-

dows Logo testing. Click Continue Anyway each time it appears.

c. When the installation is complete, click Finish.

2.2  Open PSoC Programmer by going to the Windows Start menu and selecting All Programs 

 

Cypress MicroSystems 

 PSoC Programming  PSoC Programmer.