Metrel MD 9030 Digital-Multimeter, DMM, 20991441 Hoja De Datos
Los códigos de productos
20991441
MD 9030 TRMS Electrical & Electronic DMM with Temperature
Operation
10
CAUTION
When measuring a 3-phase system, special attention should be taken to the phase-to-
phase voltage which is significantly higher than the phase-to-earth voltage. To avoid
exceeding the voltage rating of the protection fuse(s) accidentally, always consider the
phase-to-phase voltage as the working voltage for the protection fuse(s).
Beep-Jack™ Input Warning
The meter beeps to warn the user against possible damage to the meter due to
improper connections to the
When measuring a 3-phase system, special attention should be taken to the phase-to-
phase voltage which is significantly higher than the phase-to-earth voltage. To avoid
exceeding the voltage rating of the protection fuse(s) accidentally, always consider the
phase-to-phase voltage as the working voltage for the protection fuse(s).
Beep-Jack™ Input Warning
The meter beeps to warn the user against possible damage to the meter due to
improper connections to the
A, mA, or A input jacks when other function (like voltage
function) is selected.
Temperature function
Be sure to insert the banana plug type-K temperature bead probe AMD9023 (Optional
Temperature function
Be sure to insert the banana plug type-K temperature bead probe AMD9023 (Optional
purchase) with correct
polarities. Defaults at degree C (Celsius). Press SELECT
button momentarily to select degree F (Fahrenheit). You can also use a plug adapter
AMD 9024 (Optional purchase) with banana pins to type-K socket to adapt other type-K
standard mini plug temperature probes.
AMD 9024 (Optional purchase) with banana pins to type-K socket to adapt other type-K
standard mini plug temperature probes.
Relative zero
mode
Relative zero
mode allows the user to offset the meter consecutive measurements
with the displaying reading as the reference value. The display will now show readings
relative to the stored reference value. That is, display = reading - stored value. Press
the
relative to the stored reference value. That is, display = reading - stored value. Press
the
button momentarily to activate or to exit relative zero mode.