E-flite Carbon-Z EFL10250 Hoja De Datos

1.  Remove the canopy hatch before installing the wings

.

2.  Slide the wing tube (

A) into the fuselage.

3.  Install the left and right wing (

B and C) over the wing tube and into the wing 

slot of the fuselage while inserting the aileron servo connectors through the 

provided holes.

4.  Invert the fuselage so the landing gear is facing up. Secure the left and 

right wings to the fuselage using the 4 included screws (

D).

5.  Connect the aileron servos from the wings to the Y-harness connectors in 

the fuselage. The left and right aileron servos can be connected to either 

side of the Y-harness.

6.  Replace the canopy hatch on the fuselage. Engage the latch so that the 

front edge of the canopy is flush with the fuselage.

Disassemble in reverse order.

CAUTION: DO NOT crush or otherwise damage the wiring when 

attaching the wing to the fuselage.

IMPORTANT: Correct operation of the AS3X system requires connection of both 
ailerons to the included Y-harness and the AILE channel of the receiver.

If needed, use hemostats or pliers to pull the servo connectors 

into the fuselage.

The CG location is measured from the leading edge of the wing at the root. This 
CG location has been determined with the recommended Li-Po battery installed 
near the rear of the battery compartment.

back from leading 

edge at the root.