Geo PCK-EN-005 Hoja De Datos

The display is described in a separate manual. This section covers the setup and configuration of the display and
the transmitter. For these steps no expert is required.

• The included power supply unit has adapters for different countries.

Please select the correct adapter.

• The socket for the power supply cable can be found lateral at the bottom

of the display housing. The display should start then immediately with the
configuration mode.

• The buttons on the screen have the following functions during configuration:

„“ = Left: Counting up the selected figure

„O“ = Middle: Next menu item (no backward)

„“ = Right: Counting down the selected figure

The following configurations must be performed after each voltage loss. (For example, after changing the power
supply to another socket)

• Setting the time

- Hours and minutes are set in one

- By use of the buttons „“ or „“ only the minutes are changing.

The hours change only when turning over / below a full hour.

- After pressing and holding the button for a few seconds, the count rate increases.

• Setting the date: Year, month, day

With the next press of the middle button the display changes to the normal mode.

• Open the unit by pressing the plastic tab on the back of the

Transmitter and pulling the outer cover away from the bottom.

• Remove the battery tab from the Transmitter.

• The red light will flash to show that the batteries are working.

After a few seconds, the will light on the Display to
show that it is communicating with the Transmitter.



If the red LED does not flash, please check the battery contacts. You may hve to change the batteries.

If the connection between the display and transmitter was not established after a few minutes (transmitter
icon on the display does not stop flashing), you have to connect (pair) display and transmitter manually.
A description can be found in the relevant section

.