Geo PCK-EN-005 Hoja De Datos

On the display you should see consumption now.

If no consumption appears, please check cabling, control the radio link (see step 1 of this chapter), see the
Troubleshooting section.



The detection of light pulses may be impeded by exposure to light. It must be ensured that no light can
impact between LED and sensor.

With EasyMeter meter (item numbers: 125465/125467), due to the construction this may be carried out
by installing the meter in a darkened cabinet or the subsequent covering of the meter

The sensor is intended only for the optical S0 interface up to a pulse rate of 10.000 imp/kWh. However
the optical data interface D0 is not supported

With the display, other products from the range can be connected, which may provide new functionalities and further
sources of information. The integration of new devices called PAIRING.

Change for the „PAIRING“ mode by simultaneously pressing and holding the buttons „“ (left) and „“ (right) for
3 seconds. You should see now „PAIRMODE“ in the display.

• With the button „“ scroll through the slots for individual devices provided to pair.

• The button „“ has no function. Therefore, one cannot go back in the list.

• With the middle button  „O“ pairing is executed.

• An existing connection can be released this by pressing and holding the middle button „O“.

Automatically after displaying „PAIRMODE“ the first symbol is displayed.

This is the connection to the transmitter. Should a connection problem occur with the transmitter a new
connection can be established here.

The display is delivered already connected correctly, i.e. the transmitter is not in pair mode searching
for an associated display.

To establish a connection with a transmitter safely, the following steps are necessary:

1. Set the Display in „PAIRMODE“ for the Transmitter.

If you already have a transmitter connected, the Display is showing „PAIRED“. Then press and hold the middle
button „O“ for 3 s until the Display shows „PAIR ?“.

2. Now open the transmitter housing and push the only button with a pointed object for a few seconds, until the LED

starts to flash.

If the LED doesn’t start flashing, the batteries have probably run flat.

3. You should see now „PAIRED“ on the Display. The connection is completed now.



In case of problems please read the instructions at the end of this chapter.