DJI 0360005 Hoja De Datos

28 |

FAQ

Abnormal LED Indication List

During the Checking Procedure, if abnormal LED Indicator occurs or even the system cannot work normally, please

refer to the following list and aids troubleshooting.

(1)

“System initializing and self-checking LED flashes” are not correct (

Red LED

appears in the last four green flashes). The autopilot system works abnormally. Please contact your

dealer.

(2)

LED blinks Yellow 4 times quickly

(

)

The system is warming up.

You cannot start the motors until

the 4 rapid yellow flashes disappear. If the

warm up waiting is longer than 2 minutes, please power off for

5 minutes, cold start, and then

connect the assistant software, enter the "Tools" - > IMU calibration, carry

out the Advanced calibration.

(3)

After the system start and self-checking has finished, if the LED blinks Red, Green and Yellow (

)

continually. Sensor error is too big. Please connect the assistant software, enter the "Tools" - > IMU

calibration, carry out calibration.

(4)

At the first motors start, the system will check the sensors Bias and you are asked to keep the aircraft

stationary (no need of horizontal level). If you cannot start the motors and the

LED blinks Green 6 times

quickly

(

), it means that the sensor error is too big.

Please connect the assistant software,

enter the "Tools" - > IMU calibration, carry out basic calibration.

Note: after the first successful motors start, this checking will be disabled and it is no need any more to

keep the aircraft stationary during starting motors.

(5)

The system blinks Red LED quickly during flying. Low-voltage protection is triggered. Please land the

aircraft ASAP.

(6)

The system blinks Yellow LED quickly during flying. FailSafe Mode is triggered.

Pay attention that there is

no tall buildings and trees to block your aircraft during go-home.

(7)

The LED blinks Red and Yellow alternately (

). Compass error is too big.

There may be a ferromagnetic substance close to the Phantom. Lift the aircraft up about 1m from

the ground, if there is no Red and Yellow flashing, then it will not affect the flight.

Otherwise, re-calibrate the compass.

If re-calibration does not work, please connect to the Assistant Software, select the “Tools” and

follow the tips to carry out the required operation.

Fix the TBE (Toilet Bowl Effect) Problem

When flying in GPS ATTI. Mode and the compass calibration has been done correctly, should you find the aircraft

rotating (Toilet bowl effect), or drifting when hovering. Please check the GPS module mounting orientation and then