Bunn SILVER SERIES JDF-2S Manual De Usuario

FIG 3 Initial Fill Connection

INITIAL FILL

CAUTION: The dispenser must be disconnected from the

power source throughout the initial fill except when speci-

fied in the instructions.

1. Remove drip tray assembly and splash panel from the

dispenser. Replace the drip tray.

2. Connect the water source to the back of the dispenser.

3. Pull the fill tube from the dispenser, remove the plug and

connect it to the dispense nozzle.

4. Place the Dispense Lockout switch in the OFF position.

5. Connect dispenser to the power source. Press and hold

the dispense button for the dispense station that the tube

is connected to for 10 seconds, until you hear the water

valve turn on.

6. Monitor the water bath fill level until water starts to trickle

from the overflow tube. Then press the dispense button

again to stop the fill process.

7. Turn ON the refrigeration switch at the back of the dis-

penser. This will start the water bath pump circulation.

8. Check water level in the overflow tube and top off the

tank if necessary (Step 5).

9. Disconnect the fill tube and allow excess water to drain

into the drip tray. Replace the plug in the end of the fill

tube and store back into the dispenser.

10. Place the Dispense Lockout switch back to the ON posi-

tion.

11. Replace the splash panel and drip tray.

12. It will take approximately three hours at 75° F (24° C)

ambient to create the ice bank required for full dispenser

performance. During this time, some further trickling

from the water bath is expected due to expansion caused

by ice bank formation. While the refrigeration system is

creating the ice bank, the dispenser may be readied for
use as described in Loading, Priming and Adjustment.

FIG 1 Plumbing Connections

PLUMBING HOOKUP

The plumbing connection is located on the rear of the

dispenser. A 3/8” (9.52 mm) male flare adapter fitting is

supplied, installed on the rear of the dispenser.

P3580-1

FIG 2 Initial Fill Hose

P3582

P3581-1

38945 050106