Bunn TU5Q Manual De Propietario

Page 12

Weak beverage (cont.)

Dry tea leaves remain in the fun-

nel

Brewer is making unusal noises

4. Funnel Loading

5. Water Temperature

6. Low Brew Water Volume

1. Funnel Loading

1. Solenoid(s)

2. Plumbing Lines

3. Water Supply

4. Tank Heater

The BUNN

®

 paper filter must be 

centered in the funnel and the bed 

of tea leaves  leveled by gentle 

shaking.

Place an empty funnel on an empty 

dispenser beneath the sprayhead. 

Initiate a brew cycle and check the 

water temperature immediately be-

low the sprayhead with a thermom-

eter. The reading should not be 

less than 200°F. Adjust the control 

thermostat to increase the water 

temperature. Replace if necessary.

Adjust needle valve to achieve 76 

oz. water from the sprayhead when 

the batch size setting is at three 

gallons.  To increase volume, turn 

counter-clockwise.  To decrease 

volume, turn clockwise.

The BUNN

®

 paper filter must be 

centered in the funnel and the 

bed of tea leaves leveled by gently 

shaking.

The nut on the solenoid(s) must 

be tight or it will vibrate during 

operation.

Plumbing lines should not be rest-

ing on the counter top.

(A) The brewer must be connected 

to a cold water line.

(B) Water pressure to the brewer 

must not exceed 90 psi(621 kPa). 

Install a regulator if necessary to 

lower the working pressure to ap-

proximately 50 psi(345 kPa).

Remove and clean lime off the tank 

heater. See page 22

10777 041500