Century Jefferson Manual De Usuario

23

3.  Pull the top edge of the glass and frame assembly 

away from the firebox and lift it off its supports on the 
bottom of the firebox face. Place the assembly out of 
the way on a flat, padded surface such as a counter 
protected by a towel.

4.  Take the logset out of the firebox if previously in-

stalled.

5.  Remove the rear log bracket by unfastening the 

screw. (Fig. 38)

6.  Remove the right and left log bracket assembly by 

unfastening the two screws that hold the burner in 
place. (Fig. 38)

ST229a

FDV28 remove Front

12/8/99   djt

ST229a

Fig. 37  Remove stove front.

ST350

Jefferson

air shutter adj

3/20/00   djt

Remove Screws

Rear Log Bracket

Pilot

Left & Right Log 

Bracket Assembly

ST350

Fig. 38 Remove rear log bracket and left and right log bracket 
assembly.

7.  Hold the burner at the right hand side and lift to clear 

the right burner leg. Then pull to the right to clear the 
injectors on the left hand side. 

8.  The air shutter is located on the bottom of the burner 

to the left. (Fig. 39) Unfasten the two nuts holding 
the shutter in place. The shutter may be adjusted 
between the factory adjusted 1/2” to fully open. 

Reassemble the shutter to allow the rear injector air 
inlet to close from a minimum 1/2” opening to fully 
open. (Fig. 40) You may have to try more than once 
to find the correct air shutter opening for best results 
depending on your altitude.

ST352

jefferson

air shutter

new position

3/20/00   djt

Air Shutter

(Original Position)

Burner

See Table 1

ST352

Fig. 39  Air shutter in original from-the-factory position.

ST351

jefferson

air shutter

original position

3/20/00   djt

Front 
Injector 
Air Inlet

Air Shutter
(May be adjusted up to fully open)

Burner

ST351

Rear Injector Air Inlet

Fig. 40  Air shutter adjusted.

9.  Refasten the two nuts and assemble the burner into 

the unit by sliding the burner in at an angle with the 
left side lower than the right side. Slide the left side 
onto the injectors. Lower the right hand side down 
into place. Make sure the burner is as far left as pos-
sible and the injector shoulders are inside the burner. 
NOTE: It is very critical to keep the left burner leg, 
which holds the injectors at a 90° angle to the base. 
(Fig. 41) This keeps the orifices aligned with tubes 
on the inside of the burner. Failure to do so could 
affect the flame appearance and performance of the 
unit.

10.  Refasten the right and left log bracket assembly.
11.  Refasten the rear log bracket.
12.  Replace logs.
13.  Replace glass and stove front.
Follow lighting instructions on Page 26. Check flame 
color appearance. NOTE: Allow stove to burn for at 
least 1/2 hour to establish full flame color.
Should color need further adjustment, repeat Steps 1-
12 for further air shutter adjustment.