Century Jefferson Manual De Usuario

25

Read these instructions carefully and familiarize 
yourself with the burner controls shown in Figure 47. 
Locate the pilot assembly, Figure 46. Follow the lighting 
instructions on Page 26 exactly. 

During the first fire, it is not unusual to smell some 
odor associated with new logs, paint and metal being 
heated. Odors should dissipate within the first eight to 
ten hours, however, you can open a window to provide 
fresh air to alleviate the condition.

Each time you light your heater check that the pilot 
flame and burner flame patterns are as shown in Fig-
ures 48, 49, 50.  If flame patterns are incorrect, turn the 
heater off. Contact your dealer or a qualified gas techni-
cian for assistance. Do not operate the heater until the 
pilot flame is correct.

Follow regular maintenance procedures as described 
on Page 30.

For stoves equipped with HI/LO valves, flame adjust-
ment is accomplished by rotating the HI/LO adjustment 
knob located near the center of the gas control valve. 
(Fig. 47)

��

��

Turn

counterclockwise

to decrease

flame height

Turn clockwise

to increase

flame height

HV102

Honeywell hi/lo knob

4/5/99   djt

Fig. 47  Flame adjustment knob for Honeywell valve.

It is important to periodically perform a visual check of 
the pilot and the burner flames. Compare them to Fig-
ures 48, 49, 50. If any of the flames appear abnormal, 
call a service person.

ST232 

Pilot assembly location

12/9/99   djt

Thermocouple

Pilot Assembly

ST232

Fig. 46  Pilot assembly location.

ST233

pilot

12/9/99   djt

ST233

Fig. 48  Correct pilot flame appearance. PSE pilot.

CO105c

Pilot flame

4/10/00   djt

CO105c

Fig. 49  Correct pilot flame pattern. SIT valve.

ST234

JDV28

log flames

12/9/99   djt

ST234

Fig. 50  Correct burner flame appearance.