Galil DMC-1700 Manual De Usuario
90 • Chapter 6 Programming Motion
DMC-1700/1800
Parameters can be set with individual axes specifiers such as JGY=2000 (set jog speed for Y axis to 2000).
Operand Summary - Independent Axis
OPERAND DESCRIPTION
_ACx
Return acceleration rate for the axis specified by ‘x’
_DCx
Return deceleration rate for the axis specified by ‘x’
_SPx
Returns the jog speed for the axis specified by ‘x’
_TVx
Returns the actual velocity of the axis specified by ‘x’ (averaged over .25 sec)
Example - Jog in X only
Jog X motor at 50000 count/s. After X motor is at its jog speed, begin jogging Z in reverse direction at 25000
count/s.
count/s.
#A
AC 20000,,20000
AC 20000,,20000
Specify X,Z acceleration of 20000 cts / sec
DC 20000,,20000
Specify X,Z deceleration of 20000 cts / sec
JG 50000,,-25000
Specify jog speed and direction for X and Z axis
BG X
Begin X motion
AS X
Wait until X is at speed
BG Z
Begin Z motion
EN
Example - Joystick Jogging
The jog speed can also be changed using an analog input such as a joystick. Assume that for a 10 Volt input the
speed must be 50000 counts/sec.
speed must be 50000 counts/sec.
#JOY Label
JG0
JG0
Set in Jog Mode
BGX Begin
motion
#B
Label for loop
V1 =@AN[1]
Read analog input
VEL=V1*50000/10 Compute
speed
JG VEL
Change JG speed
JP #B
Loop
Position Tracking
The Galil controller may be placed in the position tracking mode to support changing the target of an absolute
position move on the fly. New targets may be given in the same direction or the opposite direction of the current
position target. The controller will then calculate a new trajectory based upon the new target and the acceleration,
deceleration, and speed parameters that have been set. The motion profile in this mode is trapezoidal. There is not a
set limit governing the rate at which the end point may be changed, however at the standard TM rate, the controller
updates the position information at the rate of 1msec. The controller generates a profiled point every other sample,
and linearly interpolates one sample between each profiled point. Some examples of applications that may use this
mode are satellite tracking, missile tracking, random pattern polishing of mirrors or lenses, or any application that
requires the ability to change the endpoint without completing the previous move.
position move on the fly. New targets may be given in the same direction or the opposite direction of the current
position target. The controller will then calculate a new trajectory based upon the new target and the acceleration,
deceleration, and speed parameters that have been set. The motion profile in this mode is trapezoidal. There is not a
set limit governing the rate at which the end point may be changed, however at the standard TM rate, the controller
updates the position information at the rate of 1msec. The controller generates a profiled point every other sample,
and linearly interpolates one sample between each profiled point. Some examples of applications that may use this
mode are satellite tracking, missile tracking, random pattern polishing of mirrors or lenses, or any application that
requires the ability to change the endpoint without completing the previous move.