Futaba 10CAG Manual De Instrucciónes
86
Flap Setting (CAMBER FLAP)(GLID):
CAMBER FLAP
assigns the primary flap control [defaults to VR(A)] to allow
LQÀLJKWWULPPLQJWKHÀDSV
7KH XSGRZQ WUDYHO RI HDFK IODS FDPEHU IODSV FLP12) can be adjusted
LQGHSHQGHQWO\$OVRWKHFHQWHUSRVLWLRQRIWKHÀDSVHUYRFDQEHRIIVHW
7KH XSGRZQ WUDYHO RI HDFK IODS FDPEHU IODSV FLP12) can be adjusted
LQGHSHQGHQWO\$OVRWKHFHQWHUSRVLWLRQRIWKHÀDSVHUYRFDQEHRIIVHW
NOTE: If FLAP-TRIM is activated, you can not use CAMBER FLAP function
simultaneously.
simultaneously.
[Note] When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display.
pressing DIAL for 1 second and canceling an alarm display.
GOAL of EXAMPLE:
STEPS:
INPUTS:
Ex: Set the maximum travel of 35% of
WKHWRWDOÀDSWUDYHO
WKHWRWDOÀDSWUDYHO
Open the CAMBER FLAP function.
for 1 second.
(If BASIC,
again.)
C
to CAMBER FLAP.
$ G M X V W W K H X S G R Z Q W U L P D P R X Q W
separately.
(Ex: adjust to 35%.)
separately.
(Ex: adjust to 35%.)
C
to FLP1.
VR(A).
to 35%.
VR(A).
to 35%. Repeat.
Option: Adjust the center position of
ÀDSVHUYR
ÀDSVHUYR
C
to CENTER.
to desired point.
Close menu.
Adjustability:
• Rate: -100% to +100%, with a default of +30%
• Center position (CENTER
• Rate: -100% to +100%, with a default of +30%
• Center position (CENTER
7KHRSHUDWLRQUHIHUHQFHSRLQWRIÀDSFDQEHRIIVHWWRZLWKDGHIDXOWRI