Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 Manual De Usuario

Installing a Brocade MLX-4 router

3

Current configuration:

!

ver V5.0.0T163

module 1 ni-mlx-20-port-1g-copper

!

This example shows that slot 1 has already been configured for a 20-port 1Gig copper 
interface module.

b. With the module designation from show running-config command output, use the no 

module <slot-number> <module-type> command to remove the configuration from slot 1.

Brocade(config)# no module 1 ni-mlx-20-port-1g-copper 

This example removes the configuration from slot 1, leaving it ready for a new module.

2. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on 

the front of the router.

3. Remove the module from the packaging.

4. Insert the module into the router slot, and slide the card along the card guide until the ejectors 

on either side of the module move close to the module front panel. Refer to 

.

NOTE

When inserting the module into the router, be sure that the faceplate does not overlap the 
faceplate of an adjacent module.

5. Rotate the ejectors until they are flush with the module front panel. This action will fully seat 

the module in the backplane.

6. Tighten the screws at each end of the module faceplate by pushing them in and turning them 

clockwise. Complete the tightening process using the flat-blade screwdriver.

7. Enter the write memory command to ensure that the slot will be correctly configured for the 

new module after a reboot.

Brocade(config)# write memory

Write startup-config done.

FIGURE 112 Installing a module

Installing Brocade MLX-4 router power supplies

You need a small Phillips or flat-blade screwdriver to install power supplies.