Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 Manual De Usuario
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
263
53-1002373-02
Installing a Brocade NetIron XMR 16000 router
4
Installing a Brocade NetIron XMR 16000 router in a rack
Keep the following precautions in mind when installing a Brocade NetIron XMR 16000 router in a
rack:
rack:
DANGER
A fully-populated Brocade NetIron XMR 16000 router is heavy. TWO OR MORE PEOPLE ARE
REQUIRED WHEN LIFTING, HANDLING, OR MOUNTING THESE DEVICES.
REQUIRED WHEN LIFTING, HANDLING, OR MOUNTING THESE DEVICES.
DANGER
Do not use the handles on the power supply units to lift or carry routers.
DANGER
Make sure the rack or cabinet housing the router is adequately secured to prevent it from
becoming unstable or falling over.
becoming unstable or falling over.
DANGER
Mount the router in a rack or cabinet as close to the floor as possible. Place the heaviest router
at the bottom and progressively place lighter routers above.
at the bottom and progressively place lighter routers above.
Because of the weight of a fully loaded Brocade NetIron XMR 16000 router, it is recommended that
you mount it in a rack before installing modules and AC power supplies.
you mount it in a rack before installing modules and AC power supplies.
You can install up to three Brocade NetIron XMR 16000 routers in a standard 19-inch (EIA310-D)
rack. You can install your device in a front-mount or a mid-mount configuration using the
factory-installed mounting brackets. For a mid-mount configuration, simply remove the brackets
from the front edges of the device and re-attach them to the center sides of the device using the
pre-drilled holes.
rack. You can install your device in a front-mount or a mid-mount configuration using the
factory-installed mounting brackets. For a mid-mount configuration, simply remove the brackets
from the front edges of the device and re-attach them to the center sides of the device using the
pre-drilled holes.
You must provide four standard #12-24 pan-head screws for each Brocade NetIron XMR 16000
router that you install in a rack. To perform this task, you will need a #2 Phillips screwdriver.
router that you install in a rack. To perform this task, you will need a #2 Phillips screwdriver.
Follow these steps to mount a Brocade NetIron XMR 16000 router in a rack.
1. Determine the position of each router in the rack. For example, mount a router with the fewest
modules near the top, a router with more modules near the middle, and a fully populated
router near the bottom of the rack.
router near the bottom of the rack.
2. Position the four mounting screws for each router in the rack posts according to the spacings
of the keyhole slots (the ones with the narrow portion pointing up) on the mounting brackets as
shown in
shown in
. When tightening the screws, leave approximately 1/4 inch clearance
between the back of the screw head and the rack post.