Marvel M18AFWPL Hoja De Especificaciones

10

Before placing the cabinet in opening, the depth of the 

cut-out opening should be at least 24 inches. If the cut-

out opening depth is more than 24 inches, then a piece of 

wood must be secured crosswise on the wall into the studs 

at the height of the anti-tip brackets. (See Figure 9 and 11). 

Slide the cabinet into position and level the cabinet with 

adjustable rear roller and front leveling legs. (See Leveling 

the unit on page 11). 

The anti tip bracket is fastened to the cabinet and runs the 

full width of the cabinet. Locate a wall stud behind the cabi-

net and secure the anti-tip bracket with at least (2) #8 x 1

1

⁄

2

” 

screws provided. See Figure 8.

Locate a wall stud behind the unit that is suitable for secur-

ing the 5” anti-tip bracket to the wall. The position of the 

bracket should be to the right of the power module and not 

behind the power module. Do not disturb the power module 

gasket on the left side of the unit. Place the anti tip bracket 

on top of the cabinet flush with the back of the cabinet. 

Mark and drill at least three holes (1/8” (3.2mm) into the 

top of the cabinet and secure the bracket to the top of the 

cabinet with at least (3) of the #8 x 

5

⁄

8

” screws provided. Se-

cure the bracket to the wall stud with at least (2) #8 x 1

1

⁄

2

” 

screws provided. See Figure 10.

-Wall stud

-Anti-tip

bracket 

on top of 

cabinet

-At least 2 

screws into 

wall stud.

Figure 8

18” and 24” wide freezers

-Crosswise

lumber

Figure 9

18” or 24” wide freezers

Figure 10

30” and 36” wide freezer

-Wall stud

-Anti-tip

bracket 

on top of 

cabinet

-At least 2 

screws into 

wall stud.

Figure 11

30” and 36” wide freezer

Crosswise

lumber-