Marvel M18AFWPL Hoja De Especificaciones

8

•  Do not use an extension cord with this appliance. 

They can be hazardous and cause deficient 

operation.

•  This unit should not, under any circumstances, be 

installed to an un-grounded electrical supply.

•  Do not remove the grounding prong from the 

power cord.

•  Do not use an adapter.

•  Do not splash or spray water from a hose on 

the appliance. Doing so may cause an electrical 

shock, which may result in severe injury or death.

Provide a 115 volt, 60 cycle, single phase 15 amp, AC re-

ceptacle. It is recommended that a separately fused circuit 

(a time delay fuse or circuit breaker is recommended), 

serving only this appliance, be provided. Electrical opening 

should be placed 78

1

⁄

2

" (199.4cm) minimum from the floor. 

(See Figure 4).

This product is factory equipped with a power supply 

cord that has a three-pronged, grounded plug. It must be 

plugged into a mating grounding type receptacle in ac-

cordance with the National Electrical Code and applicable 

local codes and ordinances. If the circuit does not have a 

grounding type receptacle, it is the responsibility and obli-

gation of the customer to provide the proper power supply. 

The unit must be installed according to your local building 

codes and ordinances.

Ice maker water supply line, 

1

⁄

4

" (6.4mm) outside diameter 

copper tubing to come up the rear of cut out opening ap-

proximately 78" (198.1cm) off the floor depending on height 

adjustment. Tubing should then pass around the right side 

of the power module and around the front to the water sole-

noid valve. See Figure 5.

When installing the water line for the ice maker, be sure 

to install a SHUT-OFF VALVE at a convenient location 

between the freezer and the supply line. Required water 

pressure range is 20 to 120 psi (138 to 827 kPa).

Also recommended is an in-line WATER FILTER between 

the freezer and the supply line to prevent sediment from 

blocking water flow through the water solenoid valve.

An ideal location for these items is on top of the cabinet, 

behind the grill, and to the right of the power module.

Self-piercing water valves and plastic tubing are 

NOT ap-

proved for water supply to ice maker.