Panasonic KX-TG6502 Manual De Usuario

If the handset display shows error messages, see “If the Following Appear on 
Your Display...” (p. 92–94) for the Cause & Remedy.

Wrong handset

Refer to manual

• The accessory handset for this base unit is 

KX-TGA650. To order, see page 3. Your handset is 
not for this base unit. Your handset is for KX-TG5200/
KX-TG5202/KX-TG5210/KX-TG5212/KX-TG5230/
KX-TG5240/KX-TG5243/KX-FPG391 base unit. 

“No link to base.
Move closer to
base and try
again.” is displayed and an 

alarm tone sounds.

• The handset has lost communication with the 

base unit. Walk closer to the base unit, and try 
again.

• Confirm the base unit’s AC adaptor is plugged in.
• Raise the base unit antennas.
• The handset’s registration may have been 

canceled. Re-register the handset (p. 90, 91).

Static, sound cuts in/out, fades. 
Interference from other 
electrical units.

• Move the handset and base unit away from 

other electrical appliances (p. 6).

• Walk closer to the base unit.
• Raise the base unit antennas.
• Turn on the Clarity Booster feature (p. 36).
• If the unit is connected to a telephone line with 

DSL service, you may hear noise from the 
receiver or speaker during conversations. We 
recommend connecting a noise filter (contact 
your DSL service provider) to the telephone line 
between the base unit and the telephone line 
jack.

The base unit/handset does 
not ring.

• The ringer volume is turned off. Set to high, 

medium, or low (p. 24, 25).

• If more than 1 other user is using the handset 

and/or base unit, the handset/base unit may 
not ring. Users will hear incoming call tones 
(p. 68) during a call or in room monitor mode.

The handset display is blank.

• If the handset display is blank, fully charge the 

battery (p. 16).

TG6500.book  Page 94  Friday, June 25, 2004  6:56 PM