Invacare 1150704 Manuel D’Utilisation

SECTION 2—ASSEMBLY

Attaching the Battery Charger Mounting Bracket to the Wall

NOTE: For this procedure, refer to FIGURE 2.2.

Place the battery charger mounting bracket on the wall at the desired position.

With a pencil, mark the middle hole position.

Measure down 6½ inches from the pencil mark and drill one mounting hole.

Install the bottom mounting screw until there is a 1/8‐inch gap between the screw head and the wall.

Put the battery charger mounting bracket onto the bottom mounting screw.

Drill the other two mounting holes.

Screw the mounting screws through the battery charger
mounting bracket and into the wall. Tighten securely.

CAUTION

Make sure there is an audible click when mount-

ing battery on the battery charger to confirm

proper mounting. Otherwise, injury or damage

may occur.

Put the battery charger in place on the mounting bracket.

Plug the battery charger into an electrical outlet.

NOTE: An LED will illuminate when power is applied to battery
charger.

Attaching the Battery Charger to the

Mast Assembly

WARNING

If the battery charger is attached to the mast

assembly and is plugged into a wall outlet, make

sure to unplug the battery charger from the wall

outlet BEFORE using the patient lift. Failure to

unplug the battery charger may result in injury

or damage.

NOTE: For this procedure, refer to FIGURE 2.3.
1.

Lock the rear casters to secure the lift in place while
performing this procedure.

Remove the two mylar pieces covering the battery charger
mounting holes on the back of the mast assembly.

Insert the hook screws into mounting holes.

Tighten the hook screws.

Mount the battery charger mounting bracket on the hook
screws.

FIGURE 2.2 Attaching the Battery Charger Mounting

FIGURE 2.3 Attaching the Battery Charger to the Mast

Mounting Bracket

Mounting Screws

Bottom Mounting Screw

Battery and Battery Charger

shown in place