Invacare 1150704 Manuel D’Utilisation

SECTION 8—ACCESSORIES

Installing the Jasmine Scale

NOTE: For this procedure, refer to FIGURE 8.2, Detail “A”.

WARNING

The Jasmine Scale MUST be installed in the orientation shown in FIGURE 1. Otherwise, injury may

occur.

NOTE: If the scale is installed incorrectly, the swivel bar or cradle attachment will not rotate freely, limiting patient movement during transfer.

Align the holes in the top rubber cap, the holes in the Jasmine scale mounting bracket and the nylon spacers with the holes in
the boom mounting bracket. Refer to Detail “A” for hardware orientation.

Attach the Jasmine scale to the boom mounting bracket with a screw, washer, bearings, flat washer and locknut. Refer to Detail
“A” for hardware orientation.

NOTE: Ensure the shaft of the screw passes through both sides of the boom mounting bracket.

Installing the Swivel Bar or Cradle Attachment

NOTE: For this procedure, refer to FIGURE 8.2, Detail “B”.

NOTE: The cradle attachment attaches in the same way that the swivel bar attaches to the Jasmine Scale.

Put the washers on the swivel bar pin.

Insert the swivel bar pin through the swivel bar.

Align the holes in the swivel bar pin with the hole in the bottom of the Jasmine scale mounting bracket.

Attach the swivel bar pin to the Jasmine scale with a screw and locknut. Tighten securely.

Snap a side rubber cap into place on each side of the boom mounting bracket.

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is

tightened securely - otherwise injury or damage may occur.

FIGURE 8.2 Installing the Jasmine Scale

Locknut

Swivel Bar

Washers

Swivel Bar Pin

Jasmine Scale

Locknut

Nylon Spacers

Flat Washer

Top Rubber Cap

Bearing

Side Rubber Cap

(2 total, 1 per side)

Boom Mounting Bracket

Screw

Bearing

Washer

Screw

DETAIL “B” -

ATTACHING THE SWIVEL BAR

DETAIL “A” -

INSTALLING THE SCALE

Jasmine Scale

Mounting Bracket