Cisco Systems 78-10588-03 Manuel D’Utilisation
Chapter 3
Installing the Chassis
Connecting Power
3-8
Cisco Metro 1500 Series Hardware Installation Guide
78-10588-03
Step 5
Hold the module in position after making full contact and use the two screws on
the front panel of the module to secure it in the housing. When the module is in
contact with the backplane, the green power LED is on.
the front panel of the module to secure it in the housing. When the module is in
contact with the backplane, the green power LED is on.
Step 6
Save the blank filler panels with the packaging material.
Connecting Power
The system is equipped with two power supplies and two power cords. The power
must be turned on by the power keyswitch on the AC-powered version only. The
keyswitch is secured against rotation and the key can be removed in either the on
or off position. A key for powering up the system is provided with each system.
must be turned on by the power keyswitch on the AC-powered version only. The
keyswitch is secured against rotation and the key can be removed in either the on
or off position. A key for powering up the system is provided with each system.
When the power is on, all of the green power supply LEDs should be on for each
power supply module (PSM) and wavelength channel module (WCM). The
display panel provides important system information.
power supply module (PSM) and wavelength channel module (WCM). The
display panel provides important system information.
Warning
The plug-socket combination must be accessible at all times
because it serves as the main disconnecting device.
because it serves as the main disconnecting device.
Warning
This unit might have more than one power cord. To reduce the risk
of electric shock, disconnect the two power supply cords before
servicing the unit.
of electric shock, disconnect the two power supply cords before
servicing the unit.
Caution
Please use approved extension cords or a power circuit breaker to
allow front power access.
allow front power access.