Nilfisk-Advance America 5200B Manuel D’Utilisation

6

Terra™ 5200B – 146 1996 000(2)2004-08

Hydraulic diagram
(See Fig. AG)
1.

Hydraulic oil tank

2.

Hydraulic oil filter

3.

Hydraulic pump

4.

Motor

5.

Safety valve

6.

Hopper lifting cylinder

Under the hood, outside the electrical box, there are the 
following fuses:
–

Thermal circuit breakers, which can be reset by 
pressing the related key:
– Main broom motor (5, Fig. V)
– Right side broom motor (6, Fig. V)
– Left side broom motor (7, Fig. V)

Lamellar fuses, protected by a transparent plastic 
lid, protect the indicated circuits:
– F1 (15 A) (the first starting from above): Ignition 

switch

– F2 (20 A): Hydraulic pump
– F3 (10 A): Hopper actuator
– F4 (15 A): Filter shaker
– F5 (10 A): Services
– F6 (10 A): Working lights (optional)
– Spare 1 (20 A)
– Spare 2 (15 A)

Inside the electrical box (12, Fig. V), there is the following 
fuse:
–

F0 (150 A): Main (2, Fig. Z) 

In addition to the standard components, the machine can 
be equipped with the following accessories/options, 
according to the machine specific use:
–

Main and side brooms with harder and softer bristles;

–

Antistatic polyester or polyester BIA C dust filter;

–

Pocket filter;

–

Pivoting light;

–

Working light;

–

Non marking skirt;

–

Non marking wheels;

–

Over head guard.

For further information concerning the optional 
accessories apply to an Authorized Retailer.

While reading this manual, the Operator must pay 
particular attention to these symbols.
Do not cover these plates for any reason, in case of 
damage replace them immediately.

The machine requires one 24 V battery, or four 6 V 
batteries connected according to the diagram (15, Fig. V).
The machine can be set in one of the following modes:
a)

Battery already installed and ready to be used.
1. Open the hood (13, Fig. C) and hold it by using the 

related rod (16, Fig. V).
Check that the battery is connected to the 
machine through the appropriate connector (4, 
Fig. V).

2. Disengage the lock rod and lower the hood, and 

ensure that it is correctly closed.

3. Insert the ignition key in the switch (18, Fig. B) in 

the control panel and turn it to “I” position (without 
activating the pedal 20, Fig. B). If the green 
warning light (9, Fig. B) turns on, the battery is 
ready to be used.
If the yellow or red warning lights (8 or 7, Fig. B) 
turn on, it is necessary to charge the batteries 
(see the procedure in the Maintenance chapter).

Battery installed on the machine but without 
electrolyte
1. Open the hood (13, Fig. C) and hold it by using the 

related rod (16, Fig. V).

2. Remove the battery caps (3, Fig. V).