Husqvarna LTH125 Manuel D’Utilisation
17
CUSTOMER RESPONSIBILITIES
BATTERY (See Fig. 16)
Your tractor has a battery charging system which is suffi-
cient for normal use. However, periodic charging of the
battery with an automotive charger will extend it's life.
cient for normal use. However, periodic charging of the
battery with an automotive charger will extend it's life.
•
Acid solution level in each battery cell should be even
with bottoms of vent wells. Add only distilled or iron free
water if necessary. Do not overfill.
with bottoms of vent wells. Add only distilled or iron free
water if necessary. Do not overfill.
•
Keep battery and terminals clean.
•
Keep battery bolts tight.
•
Keep vent caps tight and small vent holes in caps open.
•
Recharge at 6 amperes for 1 hour.
TO CLEAN BATTERY AND TERMINALS -
Corrosion and dirt on the battery and terminals can cause
the battery to "leak" power.
the battery to "leak" power.
•
Open battery box door.
•
Disconnect BLACK battery cable first then RED bat-
tery cable and remove battery from tractor.
tery cable and remove battery from tractor.
•
Wash battery with solution of four tablespoons of
baking soda to one gallon of water. Be careful not to get
the soda solution into the cells.
baking soda to one gallon of water. Be careful not to get
the soda solution into the cells.
•
Rinse the battery with plain water and dry.
•
Clean terminals and battery cable ends with wire brush
until bright.
until bright.
•
Coat terminals with grease or petroleum jelly.
•
Reinstall battery (See "INSTALL BATTERY" in the
Assembly section of this manual).
Assembly section of this manual).
TRANSAXLE COOLING
The fan and cooling fins of transmission should be kept
clean to assure proper cooling.
clean to assure proper cooling.
Do not attempt to clean fan or transmission while engine is
running or while the transmission is hot.
running or while the transmission is hot.
•
Inspect cooling fan to be sure fan blades are intact and
clean.
clean.
•
Inspect cooling fins for dirt, grass clippings and other
materials. To prevent damage to seals, do not use
compressed air or high pressure sprayer to clean
cooling fins.
materials. To prevent damage to seals, do not use
compressed air or high pressure sprayer to clean
cooling fins.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and fluid mainte-
nance is not required for the life of the transaxle. Should the
transaxle ever leak or require servicing, contact your near-
est authorized service center/department.
nance is not required for the life of the transaxle. Should the
transaxle ever leak or require servicing, contact your near-
est authorized service center/department.
V-BELTS
Check V-belts for deterioration and wear after 100 hours
and replace if necessary. The belts are not adjustable.
Replace belts if they begin to slip from wear.
and replace if necessary. The belts are not adjustable.
Replace belts if they begin to slip from wear.
CUT AWAY VIEW
FIG. 16
VENT CAP
VENT
WELL
WELL
BATTERY
CELL ACID
LEVEL
CELL ACID
LEVEL