Metrologic Instruments MS1690 Focus Manuel D’Utilisation

 

 

11

I

NSTALLING THE 

S

CANNER TO THE 

H

OST 

S

YSTEM

 

 

 
1.  Turn off the host device. 

 

2.  Plug the male 10-pin RJ45 end of the 

USB cable into the 10-pin socket on  
the scanner.  There will be an audible 
click when the connector lock engages. 

 

3.  Plug the USB type A end of the USB 

cable into the host’s USB port. 

 

4.  Turn on the host device. 
 
5.  The scanner will start to initialize.  All 

LEDs (yellow, white, and blue) will light 
for approximately two seconds then start 
to alternately flash.  When the scanner  
has finished initializing the LEDs will 
stop flashing and the unit will beep 
three times indicating that the scanner is 
ready for use.  

 
 

As a default, the MS1690-38 leaves the factory with USB Keyboard 
Emulation Mode enabled. 

 

For information on configuring the MS1690-38 for USB Serial Emulation 
Mode, please refer to the USB section of the MetroSelect Single-Line 
Configuration Guide (

MLPN

 00-02544). 

   

Plugging the scanner into a port on the host device does not guarantee 
that scanned information will be communicated properly to the host 
device.  The scanner is shipped from the factory configured with default 
settings.  Please refer to the MetroSelect Single-Line Configuration 
Guide (

MLPN 

00-02544) or MetroSet2’s help files for instructions on 

changing the scanner’s configuration.  In addition, please check that the 
scanner and host system are using the same communication protocol.