Metrologic Instruments MS1690 Focus Manuel D’Utilisation

 

 

10 

I

NSTALLING THE 

S

CANNER TO THE 

H

OST 

S

YSTEM

 

S

 
1.  Turn off the host device.  
 
2.  Plug the male 10-pin RJ45 end of the 

MVC cable into the 10-pin socket on 
the scanner.  There will be an audible 
click when the connector lock 
engages. 

 
3.  Connect the other end of the MVC 

cable to the host device. 

 
4.  Turn on the host device. 
 
5.  The scanner will start to initialize.   

All LEDs (yellow, white, and blue) will 
light for approximately two seconds 
then start to alternately flash.  When 
the scanner has finished initializing 
the LEDs will stop flashing and the 
unit will beep three times indicating 
that the scanner is ready for use.  

 
 
 
 
 
 
 
 

S

 

 

 
 

Plugging the scanner into a port on the host system does not guarantee 
that scanned information will be communicated properly to the host 
system.  The scanner is shipped from the factory configured with default 
settings.  Please refer to the MetroSelect Single-Line Configuration 
Guide (

MLPN 

00-02544) or MetroSet2’s help files for instructions on 

changing the scanner’s configuration.  In addition, please check that the 
scanner and host system are using the same communication protocol.