FieldServer FS-8700-105 Manuel D’Utilisation
FS-8700-105_National_Time_and_Signal_FACP Manual
Page 8 of 25
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
Length
Length of Map Descriptor. Specifies the number
of ports processed by the MD.
Thus if address is 1 and length is 10 the Map
Descriptor processes ports 1... 9 inclusive.
of ports processed by the MD.
Thus if address is 1 and length is 10 the Map
Descriptor processes ports 1... 9 inclusive.
1, 2, 3 etc.
Ensure that the
length added to the
offset is no greater
than the Data Array
length.
Ensure that the
length added to the
offset is no greater
than the Data Array
length.
Sub-Port-
Type
Type
Set this parameter to ‘None’ to store data for a
range of ports which do not have sub-ports. To
store data for a specific port, set the sub-port type
appropriately. If the sub-port-type is ‘Other’, it
must be specified in the configuration file as
‘S(Other)’ or 'S'. Only the first character is used,
therefore the configuration may omit the rest of
the term (e.g. it is sufficient to specify ‘I’ for
‘Input’)
range of ports which do not have sub-ports. To
store data for a specific port, set the sub-port type
appropriately. If the sub-port-type is ‘Other’, it
must be specified in the configuration file as
‘S(Other)’ or 'S'. Only the first character is used,
therefore the configuration may omit the rest of
the term (e.g. it is sufficient to specify ‘I’ for
‘Input’)
Input; Output;
Fault; S(other);
None
Fault; S(other);
None
Sub-Port
May be omitted if sub-port-type=None.
1,2,3 etc
4.1.3.
Timing Parameters
Scan_Interval
This commonly used parameter has no meaning for this
driver as the driver is a passive client driver and does not
poll for data.
driver as the driver is a passive client driver and does not
poll for data.