Emerson 752I Manuel D’Utilisation
System Controller:
I2C Interface
5-8
EEPROMs
The MV64460 uses an 8-kilobyte serial EEPROM at hex location 53
16
on the I
2
C bus to store
configuration data. Also, the MV64460 provides a second 8-kilobyte serial EEPROM at hex
location A6
location A6
16
on the I
2
C bus to provide additional non-volatile information such as board,
monitor, and operating system configurations. All Emerson-specific data is stored in the
upper 2 kilobytes of the device. The SROM data organization is allocated as follows.
upper 2 kilobytes of the device. The SROM data organization is allocated as follows.
Table 5-2:
NVRAM Allocation
I
2
C INTERFACE
The MV64460 has a built-in inter-integrated circuit (I
2
C) interface that supports master and
slave I
2
C devices. The following devices connect to the I
2
C bus:
• SO-DIMM SDRAM
• two 64-kilobit serial EEPROMs
• real-time clock (RTC) device
• Zircon PM IPMI controller and associated devices
actually consists of two switches. One switch allows the
750GL processor to access the IPMI serial ROMs only while the IPMI controller is held in
reset. The second switch allows the 750GL processor to access I
reset. The second switch allows the 750GL processor to access I
2
C Port #1 only while back-
end power is up–otherwise this connection is isolated. (Please refer to the Katana
schematics for details.)
Address Offset:
Name:
Window Size:
0x1E00-0x1FFF
Reserved
0x0200 (512) bytes
0x1DDC-0x1DFF
BootVerify parameters
0x0024 (36) bytes
0x1DD8-0x1DDB
Power-on self-test (POST) diagnostic results
0x0004 (4) bytes
0x1800-0x1DD7
Monitor configuration parameters
0x05D8 (1496) bytes
0x1600-0x17FF
Operating system
0x0200 (512) bytes
0x0000-0x15FF
User Defined
0x1600 (5632) bytes