Q-Logic 8200 Manuel D’Utilisation

6–iSCSI Noninteractive Commands

-ipdhcp (Configure IP Settings)

SN0054667-00  C

6-13

Where:

To set the adapter to get its IP address, subnet mask, and gateway from the 
DHCP server, issue the -ipdhcp command as follows:

-ipdhcp <hba_port_inst> [-option]

If the adapter port had prior values set manually, the DHCP values replace them.

Where [option] includes: 

<hba_port_inst> = The specific adapter to which the data is written
<hba_port_inst_

source>

= The file with the adapter configuration you want.

A = Configure all imported parameters (F, N, I, T, C, B).
F = Configure the firmware.
N = Configure the network parameters.
I = Configure the iSCSI name.
T = Configure the targets.
C = Configure the CHAP table.
B = Configure the boot parameters (only valid when the

T [targets] parameter is also specified).

file_name = The XML file with the adapter configuration. See 

-DISN4 = Disable IPv4 network 

-IPV4DHCP = Set DHCP ON 

-IP = Set IP Address

-IPNM = Set IP Netmask
-IPGW = Set IP Gateway

-DISN6 = Disable IPv6 network setup
-IPLLA = Set local link address automatically

-IPLL = Set local link address manually
-IPRA = Set IPR0 and IPR1 automatically
-IPR0 = Set routable address 0 manually
-IPR1 = Set routable address 1 manually

-IPRAA = Set router address automatically

-IPRR = Set router address manually