Q-Logic 8200 Manuel D’Utilisation

6–iSCSI Noninteractive Commands

-nh (Configure iSCSI Settings)

SN0054667-00  C

6-19

To set everything automatically, issue the following commmand:

To disable the IPv4 network, issue the following command:

-netconf6 0 -DISN4 

To disable the IPv4 and IPv6 networks, issue the following command:

To set the adapter-level parameters for multiport adapters, issue the -nh 

command as follows:

-nh <hba_port_inst> <Config name | Config alias> <Value>
[<<Config name | Config alias>> <Value> …]

The valid parameters and their values are shown in 

.

To add persistent targets, issue the -pa command as follows:

-pa <hba_port_inst> <IP Address> [-PORT port number] [-INAME iSCSI 
Name]

If you do not specify a port number [-PORT port number], QConvergeConsole 

CLI uses the default number 3260. If you do not specify an iSCSI name [-INAME 
iSCSI Name], QConvergeConsole CLI uses the default value, an empty string.

To view all targets for a port, issue the -pad command as follows:

-pad <hba_port_inst>

To bind a target (make it persistent), issue the -pb command as follows:

-pb <hba_port_inst> <Target ID>

To set the primary boot code boot target and LUN, issue the -pbootcode 

command as follows:

-pbootcode <hba_port_inst> <tgt> <lun>