Brother T76 Manuel D’Utilisation
52
Chapter 10
Changing the Remote Access Code
Enter your Remote Access Code when the fax machine picks up your call, so you can access features
remotely. The access code is preset to 1 5 9
remotely. The access code is preset to 1 5 9
, but you can change this.
1
Press
Menu/Set
,
8
,
3
.
2
Enter a three-digit number from 000 to 900, and press
Menu/Set
.
The
cannot be changed. Do not use the same digits that appear in your Remote Activation or
Deactivation Code.
3
Press
Stop
to exit.
Using Your Remote Access Code
1
Dial your fax machine phone number from a touch tone phone.
2
When your fax machine answers and beeps, immediately enter your Remote Access Code
(1 5 9
(1 5 9
).
3
The fax machine signals if there are any messages received:
1 long beep—Fax message(s)
No long beep—no messages
4
The fax machine then prompts you with two short beeps to enter a command. If you wait longer
than 30 seconds to enter a command, the machine hangs up. If you enter an invalid command,
the machine beeps three times.
than 30 seconds to enter a command, the machine hangs up. If you enter an invalid command,
the machine beeps three times.
5
Press
9
0
to reset the machine when you finish.
6
Hang up.
If your fax machine is set to MANUAL mode, you can access your machine
remotely by phoning it and letting it ring for about 100 seconds. Your fax machine
will answer the phone after 100 seconds of ringing, and you then have 30 seconds
to enter your Remote Access Code.
remotely by phoning it and letting it ring for about 100 seconds. Your fax machine
will answer the phone after 100 seconds of ringing, and you then have 30 seconds
to enter your Remote Access Code.