Brother T76 Manuel D’Utilisation

   Remote Fax Options (FAX-T74)   

Follow the commands below to access features remotely. When you call the fax machine and enter 
your Remote Access Code (1 5 9 

), the system will signal you with two short beeps to enter a 

remote control command.

1 OFF

If you hear one long beep, the change is accepted.  If you hear 
three short beeps, you cannot change it because the 
conditions (ex. registering fax forwarding) have not been 
completed.  You can register your fax forwarding number by 
using 4. FAX FWD NO.  Once you have registered the 
number, the machine will automatically turn to “FAX FWD 
: ON” mode.  Then, receive a Memory Status List by entering 
961.  Check the List to make sure the Fax Forwarding 
number you registered is correct.  Then enter the 
confirmation command 955.  Now the machine will start Fax 
Forwarding.

2 Fax forwarding

4 FAX FWD No.

6 FAX STORAGE ON You can set FAX STORAGE ON or OFF.

7 FAX STORAGE OFF

1 Memory Status List

You must use a remote fax machine in order to receive a List 
or stored fax message(s).

2 Retrieve all FAX

3 Erase FAX in the 

memory

If you hear one long beep, you can erase fax message(s) from 
the memory.

You can check whether your fax machine has received any 
fax message(s).  If yes, you will hear one long beep.  If no, 
you will hear three short beeps.

1 DOC

If you hear one long beep, you can change the answer mode.  
If you hear three short beeps, you cannot change it.

1 TAD

2 F/T

3 FAX

After a long beep, you can exit remote control.